|
*STDIO* |
Windows Standard IO Access |
OPEN (chan[,option])"*STDIO*"
or
SELECT ... FROM "*STDIO*"
|
chan |
Channel or logical file number. | ||||||||||
|
options |
File options used to access 'stdin'/'stdout':
| ||||||||||
|
iolist |
The iolist iolist to be applied to stdin. | ||||||||||
|
*STDIO* |
Logical file name (not case sensitive). |
The *STDIO* logical file can be used in the Windows environment to gain access to the logical 'stdin' and 'stdout' files.
Normally, when running on Windows, there is no stdin or stdout attached to the PxPlus process. However, when launched from the Command line with piped input or output, the process will have a stdin or standard output file assigned by the operating system. As all IO to channel zero is effectively routed to the Windows screen, the application will need to specifically open *STDIO* in order to access these standard IO assignments.
When reading from stdin, the input is considered a system device; thus, you should issue a READ to accept individual lines or READ RECORD to read a specific length of data.
(*STDIO* functionality was added in PxPlus v7.00.)
Reading Standard Input (stdin):
dir a* | pxplus prog01
In the program "prog01", you could then read the output of the DIR command:
open (1)"*stdio*"
while 1
read (1,err=*break)R$
print R$,
wend
msgbox "all done"
Writing to Standard Output (stdout):
The following will output a sorted directory listing piping through the Windows sort command:
pxplus -mn prog02 | sort
Where the program "prog02" contains:
set_param 'SD' ! Include directory delimiter
open (1)"*stdio*"
select F$ from "." where mid(F$,1,1)<>"."
print (1)F$
next record
close (1)