|
Tracing a Program |
|
PxPlus provides the ability for a programmer to trace the execution of a program via the SETTRACE directive. Each statement will be listed as it is executed. This trace output can either be displayed or written to a file.
The trace output will contain a listing of the statement that is being executed. If a statement repeats itself, then only one occurrence of the output will be displayed. If a compound statement executes a GOSUB, FOR, or WHILE directive as other than the final directive, it will appear twice in the trace, once when the directive is executed and once when control returns to the statement.
Example:
LOAD "PRIME"
LIST
0010 INPUT "Enter test prime:",prime
0020 FOR I = 2 TO INT(SQR(PRIME))
0030 IF INT(PRIME/I)*I = PRIME THEN EXITTO 0100
0040 NEXT I
0050 PRINT "Yup, its a prime"; STOP
0100 PRINT "Nope, it ain't prime"; STOP
SETTRACE
RUN
0010 INPUT "Enter test prime:",prime
Enter test prime:11
0020 FOR I = 2 TO INT(SQR(PRIME))
0030 IF INT(PRIME/I)*I = PRIME THEN EXITTO 0100
0040 NEXT I
0030 IF INT(PRIME/I)*I = PRIME THEN EXITTO 0100
0040 NEXT I
0050 PRINT "Yup, its a prime"; STOP
Yup, its a prime
The tracing of a program remains active until either an ENDTRACE is executed or the program terminates. When trace output is sent to a file by specifying SETTRACE(chan), make sure that the file chosen does not conflict with any files in use by the program. Make sure the program does not accidentally close the file by executing a BEGIN directive. See TraceWindow.